Solved

speedtouch 530 multinat

Posted on 2004-08-04
4
830 Views
Last Modified: 2012-06-27
I have 2 public IPs. I want 84.xx.xx.78 to be point directly to 10.0.0.2 and I want the rest of the PCs to share 84.xx.xx.77. I have setup multinat on my router to do this. However, when i try and contact 84.xx.xx.78 from the outside it only gets as far as my router. If i went to www.whatismyip.com from 10.0.0.2 it will show 84.xx.xx.78. I assume I just need to set up some sort of route to map anything for 84.xx.xx.78 to 10.0.0.2 but I cannot seem to get it to work correctly.  Can anybody help?
0
Comment
Question by:ZuG
  • 2
4 Comments
 
LVL 9

Expert Comment

by:drev001
ID: 11730560
Most routers these days have a dmz option, this will forward all incoming traffic to a specified ip address. Look for something like this.
0
 
LVL 9

Accepted Solution

by:
drev001 earned 125 total points
ID: 11730602
Be careful with this option, not very secure. You can normally use port forwarding to forward specific tcp or udp ports. So if you just want to host a web server on the inside machine you'd just forward tcp port 80.

See this for more details:

http://www.portforward.com/alcatel/st530-portforwarding.htm
0

Featured Post

Microsoft Certification Exam 74-409

Veeam® is happy to provide the Microsoft community with a study guide prepared by MVP and MCT, Orin Thomas. This guide will take you through each of the exam objectives, helping you to prepare for and pass the examination.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
Even if you have implemented a Mobile Device Management solution company wide, it is a good idea to make sure you are taking into account all of the major risks to your electronic protected health information (ePHI).
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

773 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question