Solved

Question about switch (accidently closed other topic)

Posted on 2004-08-16
1
234 Views
Last Modified: 2010-04-17
Didnt mean to close my other question sorry.

I bought two 2924 catalyst switches off of ebay. I was reading this page and had some questions
http://www.cisco.com/en/US/products/hw/switches/ps607/prod_release_note09186a00800d9e0c.html#42605

1.  It looks like trunking is not supported on the non-enterprise edition version. Is that correct? I didnt get EN!
2. Is it possible to upgrade to a EN edition?
3.  The file I need to download to upgrade IOS, is a bin file correct?

Just want to make sure I dont fry something :-)
0
Comment
Question by:dissolved
1 Comment
 
LVL 50

Accepted Solution

by:
Don Johnston earned 50 total points
ID: 11815319
1. Yes, enterprise IOS is required for trunking.
2. Yes, it is possible to upgrade to the enterprise IOS.
3. Yes, the filename of the current IOS version is c2900xl-c3h2s-mz.120-5.WC10.bin

-Don
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Suggested Solutions

In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

759 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

14 Experts available now in Live!

Get 1:1 Help Now