Solved

routing traffic on two serial interfaces to the same ISP

Posted on 2004-08-23
1
197 Views
Last Modified: 2013-11-30
Currently I have four blocks of IP's: 80, 81, 82, and 83.

I have two T-1 lines coming into one router with two serial interfaces.  One t-1 line each.  I have already told my ISP to only route traffic to 80 and 81 to serial0 and 82 and 83 to serial1.  How do I do the same on my end?  I want all traffic from 80 and 81 to use serial0 and 82 and 83 to use serial1.  

I've tried using access-lists, but that seems to slow down internet connection.  Do I need route-maps?  Any help would be greatly appreciated.  Thanks.
0
Comment
Question by:pnl4good
1 Comment
 
LVL 11

Accepted Solution

by:
PennGwyn earned 250 total points
ID: 11884490
Access lists are going to block traffic that tries to go the wrong way -- that's not what you want.

Routing is normally done based on destination address.  To route based on source, you need some kind of "policy-based" routing.  I believe route-maps can do it.

0

Featured Post

Announcing the Most Valuable Experts of 2016

MVEs are more concerned with the satisfaction of those they help than with the considerable points they can earn. They are the types of people you feel privileged to call colleagues. Join us in honoring this amazing group of Experts.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
Let’s list some of the technologies that enable smooth teleworking. 
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…

679 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question