?
Solved

3com 3300 settings

Posted on 2004-08-24
3
Medium Priority
?
472 Views
Last Modified: 2008-02-26
Hi, we had a long power outage last week and a lot of problems since.

I personally have never altered anything on the switches but a predecessor could have, could any one tell me what should be set and what not on the swithch

broadcast storm control, fast ip etc etc

cisco 2600 all switches are 3com, and we connect to an NT domain with a bit of IPX thrown in and lots of ICA traffic.

I know what each one deos roughly but not sure if i should be using it or not,

this particular switch has all our servers on so dont want to "play" with settings
0
Comment
Question by:mhamer
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 27

Accepted Solution

by:
pseudocyber earned 2000 total points
ID: 11880019
Assuming it's a 10/100 switch, best practice is all ports with fast STP - I think Cisco calls it "portfast", all ports 100 Mb Full Duplex.  I like to put rate limiting on broadcast and multicast, but that's up to you.  I also like to disable ports except those which are in use - this disallows ..."other people" ... to simply plug into your network without telling you.  Also, it's real helpful to name your ports - usually something that refers to what they're plugged into.
0

Featured Post

Industry Leaders: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

ADCs have gained traction within the last decade, largely due to increased demand for legacy load balancing appliances to handle more advanced application delivery requirements and improve application performance.
This article is in regards to the Cisco QSFP-4SFP10G-CU1M cables, which are designed to uplink/downlink 40GB ports to 10GB SFP ports. I recently experienced this and found very little configuration documentation on how these are supposed to be confi…
Viewers will learn how to connect to a wireless network using the network security key. They will also learn how to access the IP address and DNS server for connections that must be done manually. After setting up a router, find the network security…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

765 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question