Solved

2600 router for inter-vlan routing?

Posted on 2004-08-25
3
538 Views
Last Modified: 2010-08-05
I am looking to buy a 2600series router so I can route in between VLANs.
Will the Cisco 2612 Router 40/16 w/IOS 12.3.9 IP/FW/IDS work?


Thanks
0
Comment
Question by:dissolved
  • 2
3 Comments
 
LVL 28

Expert Comment

by:mikebernhardt
ID: 11897943
That will be more than enough. All you need is regular IP software. That software will give you stateful firewalling capability too.
0
 
LVL 28

Accepted Solution

by:
mikebernhardt earned 125 total points
ID: 11897981
Of course, you don't need the token ring. And remember, The older 261x routers (this is one) only have 10mb Ethernet which you can still use for trunking. If you want faster speed, either get a 261x XM series, or an older 262x router. They both have fast ethernet.
0
 

Author Comment

by:dissolved
ID: 11898189
thanks mike
0

Featured Post

Why You Should Analyze Threat Actor TTPs

After years of analyzing threat actor behavior, it’s become clear that at any given time there are specific tactics, techniques, and procedures (TTPs) that are particularly prevalent. By analyzing and understanding these TTPs, you can dramatically enhance your security program.

Join & Write a Comment

In a WLAN, anything you broadcast over the air can be intercepted.  By default a wireless network is wide open to all until security is configured. Even when security is configured information can still be intercepted! It is very important that you …
In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

757 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

16 Experts available now in Live!

Get 1:1 Help Now