Want to win a PS4? Go Premium and enter to win our High-Tech Treats giveaway. Enter to Win

x
?
Solved

802.1q

Posted on 2004-08-26
1
Medium Priority
?
220 Views
Last Modified: 2010-04-17
Noticed the 2600 series supports 802.1q frame encapsulation on the 10mb interfaces now. This means it will turnk with 802.1q?  Can it trunk with ISL?

Also, I assume any switches I want to trunk have to run  802.1q too?
0
Comment
Question by:dissolved
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 28

Accepted Solution

by:
mikebernhardt earned 2000 total points
ID: 11906022
ISL is a different, cisco-proprietary VLAN tagging method and I don't believe it's supported on 10mb interfaces. Trunks need to have the same kind of tagging on both sides, so the switch side of the trunk needs to be 802.1q also..
0

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

609 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question