Solved

Viewing Bandwidth

Posted on 2004-09-03
1
218 Views
Last Modified: 2011-09-20
I have a Linksys WRT54G Router. I would like to know is there a way to log or just even view the bandwidth in each port.  So I can see what computer A is transitting at and B, C, Etc and also if posible to see the wan trafic speed as well.

0
Comment
Question by:adamn123
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 79

Accepted Solution

by:
lrmoore earned 125 total points
ID: 11980204
Short answer is - no

Long answer - you would need to use a protocol analyzer or sniffer, and even then you are limited because the switchports on the router are not configurable to give you a mirror port to put the sniffer on.

To get the information that you want, you would need a higher-end switch that uses SNMP and RMON to provide that information.
You also would have to setup the SNMP features on the router and perform a MIB-walk from a SNMP management station to find out what information you can gather from it using snmp...


0

Featured Post

Create the perfect environment for any meeting

You might have a modern environment with all sorts of high-tech equipment, but what makes it worthwhile is how you seamlessly bring together the presentation with audio, video and lighting. The ATEN Control System provides integrated control and system automation.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

733 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question