Solved

unable to establish a connection, missing file

Posted on 2004-09-08
6
490 Views
Last Modified: 2013-12-27
When dialing to establish a connection with ISP I receive the error "unable to establish a connection".  I hear the hand shake and just before the connection hits I get the error.  If I do this through IE4 I get no other error information than what I have listed, but if dial-up is activated through My Computer dail-up networking, I receive an extra error 745: An essential file is missing reinstall the Dial-Up Networking Files.  I have reload windows over the original without success. Unable to determine the file that is missing could you help me? By the BY this is windows 98 1998  new load.
0
Comment
Question by:khoppen
6 Comments
 
LVL 5

Expert Comment

by:lidsky
ID: 12008037
Check out http://www.modem-help.co.uk/help/dun745.html it may help you.
0
 

Expert Comment

by:potlicker
ID: 12080782
DUNS ERROR 745
745 - An essential file is missing. Re-install Dial-Up Networking

Windows 95/98/Me

This error may occur if a dial-up networking .dll file is missing or damaged.

Microsoft has published an article describing how to resolve this problem. Removing and re-installing dial-up networking may not resolve this problem, and it may be necessary.
This error can also occur if the password list (.pwl) file is damaged. In addition to DUNS Error 745, other errors may occur including invalid page faults, a TCP/IP warning, and/or the computer locking up. See MS KB#154092.

0
 

Author Comment

by:khoppen
ID: 12145705
Found that during system load it was telling me to leave the cd in drive and remove the floppy.  By mistake I removed both thus causing a partical load of the system files. Thanks again for the help.
0
 
LVL 1

Accepted Solution

by:
Computer101 earned 0 total points
ID: 12393449
PAQed, with points refunded (250)

Computer101
E-E Admin
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Deploying additional Sonicpoints 3 148
Switch Life Expectancy? 4 63
100mbps vs. 100mbps on cat6e - Cable is 50m 6 77
Cisco 3560 switches not seeing VTP V3 12 67
This article is a how to to configure a UCS Ethernet-uplink portchannel via the console. It is easy to do and can be done quite quickly. In certain versions of the UCS manager the portchannel has issues coming up and this is a workaround. I am…
Hello All, I have been training on Multicast for a while now and whenever I start the topic , I find out that my friends /  Colleagues mention that they do not know how to test Multicast Joins. As most of the multicast would be video traffic and …

860 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question