Solved

Routing between multiple subnets on NetGear switch

Posted on 2004-09-10
1
865 Views
Last Modified: 2012-05-07
Thought he'd get more exposure over here, and it seems like it's not a Microsoft Networking Problem.

500 points:
http://www.experts-exchange.com/Networking/Microsoft_Network/Q_21124644.html
0
Comment
Question by:adamdrayer
1 Comment
 
LVL 1

Accepted Solution

by:
Spankyxeon earned 50 total points
ID: 12029661
based on what you're saying it would seem to me that the default gateway on the 10.0.2.1 and 10.0.2.5 devices have the wrong default gateway set.  Did you set the default gateway on the devices to 10.0.2.1 out of habit (the .1 part of it)?  It would need to be 10.0.2.2 based on what you've typed.

Another possibility, although I'm assuming it was just a typo on your
part:
"10.0.1.- uses only 2 ip addresses: 10.0.1.1 = trusted IP of firewall and 10.0.2.2 is the port/ip on the switch"

I'm assuming you meant 10.0.1.2 instead of 10.0.2.2.  If you meant to type what you did, then that's a problem.  The 10.0.1.1 and the 10.0.2.2 would be on different subnets, but you mention that they are the only 2 ip addresses in use on the 10.0.1. subnet.  That obviously wouldn't work because those 2 IP (the ones you provided) are on different subnets, not the same.

Lastly, it could be a problem with your f/w.  The f/w needs to know what networks exist on the inside of their private interface.  You may need to had a route statement in the f/w that says the 10.0.2.x network exists behind the 10.0.1.2 (what I believe should be the IP address of the switch that connects to the f/w).
0

Featured Post

Announcing the Most Valuable Experts of 2016

MVEs are more concerned with the satisfaction of those they help than with the considerable points they can earn. They are the types of people you feel privileged to call colleagues. Join us in honoring this amazing group of Experts.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
New firewall implementation guidance 12 89
Unable to reach an IP located on a Dell switch from an HP switch 18 68
UPS and BTU calculation 3 49
How to simulate latency? 5 40
Let’s list some of the technologies that enable smooth teleworking. 
When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…

840 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question