Solved

port trunking between CISCO Router & DELL SWITCH

Posted on 2004-09-11
5
649 Views
Last Modified: 2012-08-14
hi

howto configurte port trunking between CISCO Router WS-C3550-12T
and managed Switch PowerConnect 5224 from DELL ?

regards
anoym
0
Comment
Question by:anoym
5 Comments
 
LVL 7

Expert Comment

by:pedrow
ID: 12035823
You'll have to use dot1q trunking on the 3550 and not exactly positive about the powerconnects, but I think they're basically the same switches that you see in Foundry's edgeiron series...so, there should be some construct to allow you to 'tag' the vlans to the 'trunk' interface with the vlans you want to carry across the wire..

Sorry to be so vague, but what works relatively effortlessly on Cisco can be a chore on other platforms.

0
 
LVL 7

Expert Comment

by:pedrow
ID: 12035987
Well, it will have to be 802.1q for the Cisco and this should be a good place to start for the dell side:

http://support.dell.com/support/edocs/network/5p788/CLIG/vlan.htm#vlan

and more specifically:
http://support.dell.com/support/edocs/network/5p788/CLIG/vlan.htm#switchport_mode

hope this helps.
0
 
LVL 2

Author Comment

by:anoym
ID: 13224775
0
 
LVL 50

Expert Comment

by:Don Johnston
ID: 15913221
No comment has been added to this question in more than 21 days, so it is now classified as abandoned. I will leave the following recommendation for this question in the Cleanup topic area:

Award points to pedrow

Any objections should be posted here in the next 4 days. After that time, the question will be closed.

donjohnston
EE Cleanup Volunteer
0
 
LVL 1

Accepted Solution

by:
DarthMod earned 0 total points
ID: 15940731
PAQed with points (500) refunded

DarthMod
Community Support Moderator
0

Featured Post

What Security Threats Are You Missing?

Enhance your security with threat intelligence from the web. Get trending threat insights on hackers, exploits, and suspicious IP addresses delivered to your inbox with our free Cyber Daily.

Join & Write a Comment

Suggested Solutions

Title # Comments Views Activity
Cisco Router 1841 internal memory 2 44
Multiple Static IP addresses on Router 14 69
SSL RA VPN 7 76
NSD FAIL 2 22
In a WLAN, anything you broadcast over the air can be intercepted.  By default a wireless network is wide open to all until security is configured. Even when security is configured information can still be intercepted! It is very important that you …
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

705 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

16 Experts available now in Live!

Get 1:1 Help Now