Solved

VPN connection using Cisco Client through Belken 4 port DSL/Cable router.

Posted on 2004-09-21
1
340 Views
Last Modified: 2010-08-05
I am trying to connect to my work Cisco VPN. I have all of the correct clients and software. I am using a Cisco Client. The problem is, I am going through a 4 port Belkin dsl/cable router and I am not sure what I need to do to it to set up the special application ports to make it work. Any help will be greatly appreciated.
0
Comment
Question by:GusGallows
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 12123366
Check you router configuration pages and look for an option for VPN passthrough, or IPSEC passthrough. Make sure this option is enabled.
0

Featured Post

Simple, centralized multimedia control

Watch and learn to see how ATEN provided an easy and effective way for three jointly-owned pubs to control the 60 televisions located across their three venues utilizing the ATEN Control System, Modular Matrix Switch and HDBaseT extenders.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Windows 10 Pro and Dual Monitor RDP 10 54
SSIS with VPN COnnection 2 144
ASA 5505 latency problem 8 71
SSL VPN and open two factor authentication 3 77
Sometimes, you want your microsoft VPN to route all the traffic to the remote network. Usually your employer network. This makes it possible to access all the nodes inside this remote LAN, even if they have no "public DNS" entries. To do so, you wo…
If you use NetMotion Mobility on your PC and plan to upgrade to Windows 10, it may not work unless you take these steps.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question