I have a freshly installed Win 2003 domain controller with that cannot have the read only taken off all files on c d and e drives . I have reset permissions removed read only tick(which is grayed out as if it is inheriting it from somewhere)I have formatted d and e and copied files back over still the same, when you take the tick out of read only box and apply it goes through and looks like it works but then when you check again after exiting sharing tab and going back in the tick reappears.
I did relocate the f: drive after the install and put it into antother machine leaving me with one drive c d and e I dont know if this was the issue
Do you have that for folders only, or for files as well? If the former, that's by design and nothing to really worry about:
You Cannot View or Change the Read-Only or System Attribute of Folders
The HP utility "HP Lights-Out Online Configuration Utility for Windows Server 2003/2008" could be of great use when it comes to remotely configure a HP servers ILO WITHOUT rebooting the server.
We would only need to create and run scripts using thi…
by Batuhan Cetin
In this article I will be guiding through the process of removing a failed DC metadata from Active Directory (hereafter, AD) using the ntdsutil tool in a Windows Server 2003 environment.
These steps are not necessary in a Win…
Email security requires an ever evolving service that stays up to date with counter-evolving threats. The Email
Laundry perform Research and Development to ensure their email security service evolves faster than cyber criminals. We apply our Threat…