Solved

No https internet traffic passing through Cisco IPSEC vpn??.

Posted on 2004-10-04
1
314 Views
Last Modified: 2010-04-12
Hello!!

I have a strange issue to ask you about... I have installed two cisco 837 routers with an IPSEC vpn tunnel between the two. The tunnel works absolutly fine. End A is our head office and end B is a remote site.

I want all internet access from end B to pass through the vpn and exit from our firewall at the A end so we can control traffic. To achive this I have configured a default route in the B end;

ip route 0.0.0.0 0.0.0.0 dialer 1

At the A end router I have configured a route back to router B's LAN through dialer 1 and a default route out to our firewall.

I.e
ip route 10.1.0.0 0.0.0.255 dialer 1
ip route 0.0.0.0 0.0.0.0 10.2.0.1 (Our firewall)

From end B i can now surf the internet fine through the vpn (I have used tracert to make sure). It works until I try to access a secure https site. Nothing happens and I eventually get the dredded microsoft "this page cannot be displayed" message. I'm pretty sure it's not an access list issue because in the cause of testing i have taken them off of all interfaces and it still doesnt work.

I have also applied a logged access list on the A end's e0 interface and I can see http traffic coming in and out. But no https port 443!!

Any ideas what this might be chaps?  Thanks for your help. This ones worth 500 to ya. Ta! :)


0
Comment
Question by:needsy
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 12222491
MTU

Since you have DSL between the sites, you have a fragmentation before encryption issue..
Take a look at the issues here:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/prod_release_note09186a008015ce50.html

0

Featured Post

Technology Partners: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Like many others, when I created a Windows 2008 RRAS VPN server, I connected via PPTP, and still do, but there are problems that can arise from solely using PPTP.  One particular problem was that the CFO of the company used a Virgin Broadband Wirele…
If you use NetMotion Mobility on your PC and plan to upgrade to Windows 10, it may not work unless you take these steps.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

728 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question