?
Solved

Relink kernel

Posted on 2004-10-16
2
Medium Priority
?
357 Views
Last Modified: 2013-12-23
After the installation of Network Card and completeing the process with linking the kernel I am getting the message:
"cat: canot open /var/opt/K/Sco/link/1.1.1.E.b/etc/conf/sdevice.d/:
no such file or directory (error2)"
"idbuild: the build process had errors. System build failed".


0
Comment
Question by:javed61
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 21

Accepted Solution

by:
tfewster earned 2000 total points
ID: 12326826
What release of SCO?

Just a thought: Does that directory exist? If not, how much of the path exists?  /var/opt/K/Sco/link/1.1.1.E.b ?  Should the "Sco" directory be all upper case? Should there be a "." between the "E" & the "b"?

There is a Software Verify utility to fix broken links under /var/opt/K:
http://osr5doc.ca.sco.com:457/HANDBOOK/swaT.verify.html

You may find the following links useful:
http://www.aplawrence.com/Unixart/linkfail.html
http://www.aplawrence.com/Unixart/driverart3.html

Good luck!
0
 

Author Comment

by:javed61
ID: 12354943
Thanks for the support,
The software verify utility to fix broken links works perfectly and now it is OK

Thanks a lot

0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Did you know SD-WANs can improve network connectivity? Check out this webinar to learn how an SD-WAN simplified, one-click tool can help you migrate and manage data in the cloud.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is in regards to the Cisco QSFP-4SFP10G-CU1M cables, which are designed to uplink/downlink 40GB ports to 10GB SFP ports. I recently experienced this and found very little configuration documentation on how these are supposed to be confi…
This article explains the fundamentals of industrial networking which ultimately is the backbone network which is providing communications for process devices like robots and other not so interesting stuff.
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
In this brief tutorial Pawel from AdRem Software explains how you can quickly find out which services are running on your network, or what are the IP addresses of servers responsible for each service. Software used is freeware NetCrunch Tools (https…

719 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question