Improve company productivity with a Business Account.Sign Up

x
?
Solved

Cisco WIC 1SHDSL and ADSL line compatibility

Posted on 2004-10-19
3
Medium Priority
?
821 Views
Last Modified: 2008-03-04
Will a Cisco WIC 1SHDSL work on a standard BT ADSL line or must I use a WIC1 -ADSL?  The ADSL service is on a standard POTS line.

THanks
0
Comment
Question by:snarler45
  • 2
3 Comments
 
LVL 3

Expert Comment

by:Arl
ID: 12345972
Hi,

Apparently there is nothing against that, except that you have to take care about the connector (see article, RJ11)
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1700/1700cnts/gshdslup.htm#31169

Hope that can help.
0
 

Author Comment

by:snarler45
ID: 12347453
Thanks I have the document you point to I did not read down to step 11 put the card in the desired DSL mode :)
0
 
LVL 3

Accepted Solution

by:
Arl earned 1000 total points
ID: 12347776
that happens all the time...
but is this allright for you so ?
0

Featured Post

Improve Your Query Performance Tuning

In this FREE six-day email course, you'll learn from Janis Griffin, Database Performance Evangelist. She'll teach 12 steps that you can use to optimize your queries as much as possible and see measurable results in your work. Get started today!

Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
This article is about building a site to site VPN tunnels in Cisco CSR1000V router with IOS XE. There are two Policy Based IPsec VPN tunnels configured on CSR1000V router one with NAT and another without NAT.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

601 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question