scottparks
asked on
Lost 1600 configuration after saving to startup-config
I have a config that I loaded into a Cisco 1620 router afterwhich I:
write memory and then show conf to verify it is the config I want.
I then copy running-config startup-config and verify that both are correct.
However, upon power cycling the router all interfaces go into shutdown and I have to start
the configuration over again. Did I miss a step?
Thank you.
write memory and then show conf to verify it is the config I want.
I then copy running-config startup-config and verify that both are correct.
However, upon power cycling the router all interfaces go into shutdown and I have to start
the configuration over again. Did I miss a step?
Thank you.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Worked like a charm! Thank you!
ASKER
Thank you!