?
Solved

Cisco 3600 with Stuck Interface

Posted on 2004-11-11
2
Medium Priority
?
279 Views
Last Modified: 2010-04-17
All,
I have a Cisco 3640 and apparently I'm a moron.  12.1 IOS, 4 T's in it, nothing special, all internal routing.  Had a modem card and group sync interface in config.  Shut down that group sync interface completely and removed the card, replaced with a network mod with two wics.  I can see/configure the two new wics, but the group sync interface still resides in the configuration.  How do I go about removing the interface.  Not really hurting anything, just would like to have it gone just to make it look clean.  Thoughts?
JP
0
Comment
Question by:jpbowdoin
2 Comments
 
LVL 13

Accepted Solution

by:
Dr-IP earned 2000 total points
ID: 12554701
You could try the no interface XXXX command and see if that gets rid of it, replace the XXXX with the name and number of the interface you want to eliminate.
0
 

Author Comment

by:jpbowdoin
ID: 12555872
Dr-IP. Thanks! Knew it was simple. You rock.
JP
0

Featured Post

Get your problem seen by more experts

Be seen. Boost your question’s priority for more expert views and faster solutions

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

621 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question