[Okta Webinar] Learn how to a build a cloud-first strategyRegister Now

x
  • Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 449
  • Last Modified:

Need to connect a 2620 to a 2610 via the T1 CSU/DSU wic's

I need to connect 2 cisco 2600 series router together via the T1 CSU/DSU wic's.  I've done this many times with 2500 series routers...via the DTE/DCE v.35 serial cables from cisco....but not via the T1 CSU/DSU wic's.  This can't be that difficult....I think I'm just missing something on the serial config's....any help would be appreciated.

Thanks,

 
0
naiadmin
Asked:
naiadmin
1 Solution
 
MarkDozierCommented:
post your config so we can help you find out what is missing
0
 
Dr-IPCommented:
Are you usinig a T1 cross over cable? Pin 1 on the near end goes to pin 4 on the far end, and pin 2 on the near end goes to pin 5 on the far end, and visa versa for the far end.

c          c  
o          0
n          n
1          2

1--------4
2--------5                  
4--------1                        
5--------2                        
0
 
naiadminAuthor Commented:
That's it....I looked up T1 crossover and found the same cable config.  I made myself a cable and everything came up....I figured it was something like that... Thanks for the info.  

naiadmin
0

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now