farazoi
asked on
CFD400 Coaxial Cable.
I am trying to network 2 office premises by installing 2 yagi antenna connected to wireless access point by using CFD400 coaxial cable.i am planning to use a 100 meter coaxial cable at 1 side and 10 meter of the same cable on the other side. Will it work or will there be to much signal loss if i use 100 meter length for the coax cable. Please advise. Thanks.
OK. So the maximum cable length of one segment is 100 meters for the coax right? So the question is, is the WAP cabable of being a repeater to repeat the signal another 10 meters. I think some WAP are capable of being repeaters. Check the specs. Just a thought.
ASKER
Yes the WAP i'm using is capable of being repeaters. So can I say that if i use 100 meter of coax cable on 1 segment and another 10 meter on the other segment, there will be minimum data loss? please advise. THank you.
You know what? I don't know. I just looked at your question again and you have the CFD400 coaxial cable. I am quite unfamiliar with this. I found one good link to it.
http://nuke.freenet-antennas.com/modules.php?name=News&file=article&sid=15
I really couldn't tell you what these spec's mean. Any Wireless WAN folks in the house that can help?
http://nuke.freenet-antennas.com/modules.php?name=News&file=article&sid=15
I really couldn't tell you what these spec's mean. Any Wireless WAN folks in the house that can help?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.