ransoneb
asked on
Migrating "alias" to "Outside NAT"
I'm trying to connect to my PIX using PDM and I get an error message that says the PDM no longer supports the "alias" command and that I should migrate to Outside NAT.
the line in my start-config is as follows:
alias (inside) x.x.x.x y.y.y.y 255.255.255.255
is this the correct conversion to Outside Nat:
nat (inside) x.x.x.x y.y.y.y 255.255.255.255 outside
I did not set up the PIX, I just inherited it, hence the preference for PDM instead of CLI.
the line in my start-config is as follows:
alias (inside) x.x.x.x y.y.y.y 255.255.255.255
is this the correct conversion to Outside Nat:
nat (inside) x.x.x.x y.y.y.y 255.255.255.255 outside
I did not set up the PIX, I just inherited it, hence the preference for PDM instead of CLI.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Good job!
ASKER
All I had to do to your answer was ad [dns] between the outside addy and netmask to do outside dns resolution for me
Thanks lr