mtnbuzz
asked on
Cisco Catalyst 2950 Switch and VLAN setup
I have an VLAN setup in my core switch. I have a 2950 that I need ports 3 - 10 to connect to VLAN 3. I need the steps involved to do this.
Thanks
Thanks
ASKER
When I tried
config t
vlan 3
I recieived the following:
VTP VLAN configuration not allowed when device is in CLIENT mode
??????
config t
vlan 3
I recieived the following:
VTP VLAN configuration not allowed when device is in CLIENT mode
??????
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
vlan 3
interface range f0/3 - 10 (note space around hyphen
switchport access vlan 3
exit
wr mem