Cisco 827 Clears NVRAM after every reboot

I can type copy run start or whatever to save a new startup-config but after every reboot I get:

Would you like to enter the initial configuration dialog? [yes/no]:

How do I get it to save the configuration?
wdundoreAsked:
Who is Participating?
 
minmeiConnect With a Mentor Commented:
wdundore,

Type "show version".

If the configuration register is 0x2142, then type "config-register 0x2102" at the config prompt.

Change the 4 to a 0 in whatever you have from the show version - the 4 means ignore the NVRAM config file.

Good luck!
0
 
rshooper76Connect With a Mentor Commented:
Type "write" to save the configuration after you enter it.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.