?
Solved

need to configure a cisco 2600 wic card for e-1 interface using 12.3 ios, i cant issue the service-module command in the interface configuration its giving me syntax errors

Posted on 2005-04-29
3
Medium Priority
?
176 Views
Last Modified: 2010-04-17
i cant issue the service-module command in the interface configuration its giving me syntax errors
I have an exact router on the usa side using a t-1 module and i have no issue
0
Comment
Question by:calltek
1 Comment
 
LVL 13

Accepted Solution

by:
Dr-IP earned 2000 total points
ID: 13897433
Do a "sh controllers e1" and see if you have one listed, if you do then configure it using the sample below as a guide.

controller E1 0/0
 clock source internal
 channel-group 0 timeslots 1-30

interface Serial0/0:0
 ip address 10.10.99.1 255.255.255.252
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

829 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question