xerox worcentre xd100 h4 error

Printers I have a xerox workcentre xd100 that comes up with "h4" error. I already changed the fuser
ccrsAsked:
Who is Participating?
 
SkyvanManConnect With a Mentor Commented:
You will need to try the following to clear the fuser code.
Turn on the power and within 4 seconds press the following sequence: 'Clear', 'Exposure Mode', 'Clear', 'Exposure Mode' (Exposure Mode is the button on the far left). The console will go completely blank.
Select 14. By using the printer quantity buttons for the 1 and then press 'print' then do the second part of the code with the quanitity buttons to make it a 4 and press print again. Press clear or turn off the power to exit diagnostics mode. Turn it back on and the fuser error code should be gone.

This information is from
http://www.partsdrop.com/pages/XD100inf.html
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.