RobinsRL
asked on
Problem configuring a Cisco 3550 switch using hyperterminal
I have set the switch back to factory default config. When using hyperterminal to send a text config. file, it does not complete correctly, and I get error messages from the switch:
*Mar 1 00:36:59: %IP_SNMP-3-SOCKET: can't open UDP socket;
Unable to open socket on port 161
This switch is not hooked up to anything except the console port. I have performed this procedure many times in the past. This is the first time I have seen this. I have also tried it with another, identical switch and another text file. Same result.
Any help would be greatly appreciated.
Thank you.
*Mar 1 00:36:59: %IP_SNMP-3-SOCKET: can't open UDP socket;
Unable to open socket on port 161
This switch is not hooked up to anything except the console port. I have performed this procedure many times in the past. This is the first time I have seen this. I have also tried it with another, identical switch and another text file. Same result.
Any help would be greatly appreciated.
Thank you.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
I guess tamscodan did not see the same post directly above his ?
harbor235 ;{
harbor235 ;{
ooops sorry, LOL
I found this also for the 6400:
* CSCdk66361
The error message "IP_SNMP-3-SOCKET: can't open UDP socket" is generated whenever a Cisco 6400 NSP is booted with SNMP enabled in the system configuration. This message can be ignored.
This reference indicates a bug, what IOS are you using? it could be the same bug.
harbor235