mwalsh2000
asked on
DTSRUN Utility
I would like to set up a batch file that executes a DTS that has been created. The .bat file contents:
dtsrun /S FS2/U XXXX/P XXXXX/N MYDTSPACKAGE
When I run this at the command prompt to test it says: Must specify a package name or guid or version guid, or a source file name. I have included the package name parameter, can someone assist?
dtsrun /S FS2/U XXXX/P XXXXX/N MYDTSPACKAGE
When I run this at the command prompt to test it says: Must specify a package name or guid or version guid, or a source file name. I have included the package name parameter, can someone assist?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Also take a look at running DTSRUNUI from a command prompt--it will generate your "execute string" for a DTS package...
ASKER
Thanks, I will take a look at that as well