contactkeval
asked on
250 points internet connection setup in RH9
this is the same question asked on
https://www.experts-exchange.com/questions/21481490/DLink-ADSL-DSL-502T-router-setup-for-RH-9.html
if someone can help me in setting up net connection then i ll reward all points for above question to the same person. following is output of ifconfig command
$ /sbin/ifconfig
eth0 Link encap:Ethernet HWaddr 00:08:A1:6B:3C:C0
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1240 (1.2 Kb) TX bytes:684 (684.0 b)
Interrupt:11 Base address:0x4c00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:321 errors:0 dropped:0 overruns:0 frame:0
TX packets:321 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:21494 (20.9 Kb) TX bytes:21494 (20.9 Kb)
thanks in advance
https://www.experts-exchange.com/questions/21481490/DLink-ADSL-DSL-502T-router-setup-for-RH-9.html
if someone can help me in setting up net connection then i ll reward all points for above question to the same person. following is output of ifconfig command
$ /sbin/ifconfig
eth0 Link encap:Ethernet HWaddr 00:08:A1:6B:3C:C0
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1240 (1.2 Kb) TX bytes:684 (684.0 b)
Interrupt:11 Base address:0x4c00
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:321 errors:0 dropped:0 overruns:0 frame:0
TX packets:321 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:21494 (20.9 Kb) TX bytes:21494 (20.9 Kb)
thanks in advance
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.