giantrewards
asked on
how to check solaris t3 status?
I replaced a hard disk (73GB) in sun solaris t3 storage 3 days ago, right now, both green light and yellow light on the t3 are still blinking. Is there any command i can use to see whether this disk is running ok or what percentage of sync has been finished? Thanks a lot! btw, they are mounted as raid-5.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
If you can connect a serial console to the array, you can check the disk/volume status by issuing the "vol stat" and "vol list" commands. These are detailed in the pdf (Chap. 4.1.2) in the last link posted by yuzh above. The drives should all show status 0 if they are ok.
This pdf also explains how to enable remote monitoring of the system.