troubleshooting Question

SW - Center Marks Disappearing

Avatar of kgerb
kgerbFlag for United States of America asked on
CAD/Architecture Software
7 Comments1 Solution236 ViewsLast Modified:
I have a part with some large radius fillets (3"-4").  In my drawing I added center marks to the radaii in order to locate them but most of the center mark does not show up.  Both the vertical lines and the right line are gone.  About half of the left line is visible.  It's almost like there is an invisible boundary around the borders of the part and anything outside this boundary is cut off.  Is there some setting that might clear this up?
Join the community to see this answer!
Join our exclusive community to see this answer & millions of others.
Unlock 1 Answer and 7 Comments.
Join the Community
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 7 Comments.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros