Manuel
asked on
Using multiple public IP address for the outside interface on PIX 501
Hello,
I have three public ip address which are X.X.64.85, X.X.64.236, X.X.64.253. However, as one can see the last octect changes very much from one IP address to another so I cannot set a range I believe. I wanted to know how I can configure the global pool so that the PIX can choose one of these IP address for translation for the inside hosts?
Thank You,
Victor
I have three public ip address which are X.X.64.85, X.X.64.236, X.X.64.253. However, as one can see the last octect changes very much from one IP address to another so I cannot set a range I believe. I wanted to know how I can configure the global pool so that the PIX can choose one of these IP address for translation for the inside hosts?
Thank You,
Victor
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Yes, exactly you need the following commands:
nat (inside) 1 0 0
global (outside) 1 interface
nat (inside) 1 0 0
global (outside) 1 interface
ASKER