kevinmeredith
asked on
Panel is right size in Form Design Mode, but wrong size at run-time
In Form Design Mode I drag the panel's edges to be big enough to show 22 labels contained in it. (Panel and the labels where manually placed on the form at design mode time.) At run-time, the panel's right edge covers two or so of the labels. Doesn't dragging the panel's size at design mode time set the size? What changes it at run time?
My panel has a fixed3d or fixedsingle border.
My panel has a fixed3d or fixedsingle border.
ASKER
I wound up replacing the panel with a groupbox. The groupbox has no such problem. So this a non issue anymore. What do you suppose I should so with this question?
Post a request to have it deleted here:
https://www.experts-exchange.com/Community_Support/
https://www.experts-exchange.com/Community_Support/
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
What happens if you create a new form and do the same thing?
If it still happens, does the problem go away if you create a New PROJECT and try again?