?
Solved

Cisco 2948G Configuration GUI?

Posted on 2006-03-29
1
Medium Priority
?
1,125 Views
Last Modified: 2008-01-09
I have a new Cisco Catalyst 2948G switch and I would like to use a GUI to configure it rather than the command line.  Is there a GUI and how do I access it?
0
Comment
Question by:brendansullivan
1 Comment
 
LVL 11

Accepted Solution

by:
-Leo- earned 2000 total points
ID: 16323831
0

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
I recently attended Cisco Live! in Las Vegas, a conference that boasted over 28,000 techies in attendance, and a week of hands-on learning hosted by a solid partner with which Concerto goes to market.  Every year, Cisco displays cutting-edge technol…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

840 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question