help request: configure ATM service on Cisco 2611XM router with VWIC-1MFT-T1 wic card

Can you connect to a service provider's ATM network using the VWIC-1MFT-T1?  I was told this is the WIC I need because it is a Multifunction Trunk, but I am still not seeing any ATM options in the config screens.  Please inform if you know this is or isn't possible with the 1MFT.  If you know how to configure this, please help.

Thanks,
D
zonie4jcAsked:
Who is Participating?
 
calvinetterCommented:
Apparently you can run T1 data over ATM networks if you also have this add-on card (in addition to the VWIC-1MFT-T1): AIM-ATM

See also:
  "Providing ATM Services" section:
http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080088753.html#wp39568
  And check the minimum IOS requirements (bottom of same pg):
http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080088753.html#wp41547
  (You'll need to be running the "IP Plus" or "Service Provider" IOS feature sets.)

  Also, here's a list of ATM Network Modules for the 2600 series (I'd confirm if they're compatible w/ the 2600XM series):
http://www.cisco.com/en/US/products/hw/routers/ps259/products_relevant_interfaces_and_modules.html

For something like this, I recommend either calling Cisco pre-sales tech support (800-553-6387) or a local Cisco Reseller.

Some general config info:
  Inverse Multiplexing Over ATM (IMA):
http://www.cisco.com/en/US/tech/tk39/tk356/technologies_configuration_example09186a0080174992.shtml
  Configuring ATM - IOS 12.2/12.3:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_c/wcfatm.htm

cheers
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.