nbcintern
asked on
Backup Exec
Hello Experts,
I have the following message in Backup Exec's job status colum " Ready; Specified destination
device pool on local media server is empty. Any help?
Thanks
Backup Exec Version: 10.0 Rev 5484
I have the following message in Backup Exec's job status colum " Ready; Specified destination
device pool on local media server is empty. Any help?
Thanks
Backup Exec Version: 10.0 Rev 5484
ASKER
Yes I am pointing to the correct pool, but when I go inside and try to check for my devices it says there are no devices avilable to add.
Thanks
Thanks
http://seer.support.veritas.com/docs/257062.htm
give this a read,
and also if you can give alittle more info, on any changes that happened, specs, tape drive, HDD etc?
give this a read,
and also if you can give alittle more info, on any changes that happened, specs, tape drive, HDD etc?
ASKER
Hello Experts thanks for all the help. I open the server disconnected the tape drive and reconnected it the back, backup exec is now working fine. Don't know what was going wrong. I didn't do any changes to the hardware or software before this issue started.
hi, there
How is the tape device attached what kind of controller??
, could be a SCSI timeout on controller look in event log
How is the tape device attached what kind of controller??
, could be a SCSI timeout on controller look in event log
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Just off the top of my head....do you have the backup job pointed to the correct media pool?
Also, are there tapes allocated to that pool?
Cyan990