CLI configuration for Cisco router
Posted on 2006-05-20
I've previously used CRWS to configure my SOHO91 router, but the software has recently been upgraded. Now I can't use a GUI because:
1. The CRWS no longer connects to the router.
2. Attempts to flash the router to allow SDM to be used fail saying SDM is not supported on the router.
And I can't go back to an older version of router software because you need a Cisco service contract to download their software (and I feel a rant coming on about *this*, but that's a different subject!).
So I need to configure very simple VPN, and my only option is to use the CLI. But I have no idea where to start (the CLI commands seem to bear no relation to the CRWS ones, and I am inexperienced with Cisco). Does anyone have any ideas where I can start to find out the relevant CLI commands (or get the GUI going again)?