danw76
asked on
Cisco 2600 QoS configuration issue
Hello,
My company is using a Polycom device for video conferencing. We just upgraded our bandwidth for this office to a 3MB channel from our ISP. I need to configure QoS on my Cisco 2600 so there is reserved, dedicated bandwidth for this Polycom system whenever anyone needs the system. I am, however finding it a bit difficult to figure out how to set up QoS on a multilinked bonded pair of two, T1 WIC’s in my 2600 and I am not sure how to config QoS on such a configuration.
Any assistance would be very much appreciated and thanks in advance.
My company is using a Polycom device for video conferencing. We just upgraded our bandwidth for this office to a 3MB channel from our ISP. I need to configure QoS on my Cisco 2600 so there is reserved, dedicated bandwidth for this Polycom system whenever anyone needs the system. I am, however finding it a bit difficult to figure out how to set up QoS on a multilinked bonded pair of two, T1 WIC’s in my 2600 and I am not sure how to config QoS on such a configuration.
Any assistance would be very much appreciated and thanks in advance.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.