asked on

NCover and Nunit crashing when i try to run my tests

NCover and Nunit crashing when i try to run my tests. I have Nunit 2.2 installed along with ncover 1.3.3. using framework 1.1. When i run my test either ncover or nunit crashes, i think its ncover. does anyone have any idead how to correct this or get more information on the problem. One of the projects within the solution does allow me to run ncover and nunit but the others dont !

very strange and I have spend a week at this :(

Thanks in advance.

Andrew

andyuk

ASKER

------ Test started: Assembly: DalFactory.dll ------

NCover couldn't create a coverage report.

2 passed, 0 failed, 0 skipped, took 7.76 seconds.

test run okay :(

ASKER CERTIFIED SOLUTION

fernandonajera

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

fernandonajera

I'm convinced my answer can help andyuk. If not, using his feedback I would answer again. But, I'm not sure if this deserves an accepted answer. I think my answer should have work at first, but I'm not sure and there is no feedback...

andyuk

ASKER

Hi fernandonajera

sorry i have been snowed under with this nunit stuff then had a 2 week holiday to escape it. I kept to you solution but added a few steps. needed to install service pack 2 then the framework 2, afterwards installed all the nunit and ncover and surprisingly it all worked. I was not to keen on service pack 2 going on my dev environment due to a release going out but i took the risk in the end. :)

Thanks for your help.