Solved

Cluster node will not boot in Windows 2003

Posted on 2006-06-16
4
230 Views
Last Modified: 2013-11-15
Hi all,

I just setup a windows 2003 R2 two node cluster sharing a Network Appliance FAS250 storage device.  I tested the 'move cluster group' option  and the cluster will move between both the nodes successfully. However, now when I restart the windows 2003 nodes one of the nodes will not boot and gets stuck on the black windows 2003 screen with the scroll bar going along continuously.

Any ideas why this would happen?

Thanks,

Dean
0
Comment
Question by:DeanUnited
4 Comments
 
LVL 29

Expert Comment

by:mass2612
ID: 16923869
Hi,

You could try booting into safe mode and check the event logs or starting using debugging mode via F8 to try to see what is freezing the sstem.
0
 

Author Comment

by:DeanUnited
ID: 16954929
Thanks,

Basically it was a bad drive that the O/S was loaded on. Pulled the bad drive in the mirror and it started up.

Thanks,
0
 
LVL 1

Accepted Solution

by:
DarthMod earned 0 total points
ID: 17160004
PAQed with points refunded (300)

DarthMod
Community Support Moderator
0

Featured Post

Complete VMware vSphere® ESX(i) & Hyper-V Backup

Capture your entire system, including the host, with patented disk imaging integrated with VMware VADP / Microsoft VSS and RCT. RTOs is as low as 15 seconds with Acronis Active Restore™. You can enjoy unlimited P2V/V2V migrations from any source (even from a different hypervisor)

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Replication has always been one of those technologies that people run scared from. The main reason is usually cost. When you think of replication, your mind drifts to solutions that replicate from one disk frame to another using block level technolo…
On July 14th 2015, Windows Server 2003 will become End of Support, leaving hundreds of thousands of servers around the world that still run this 12 year old operating system vulnerable and potentially out of compliance in many organisations around t…
This tutorial will walk an individual through locating and launching the BEUtility application to properly change the service account username and\or password in situation where it may be necessary or where the password has been inadvertently change…
This tutorial will show how to configure a new Backup Exec 2012 server and move an existing database to that server with the use of the BEUtility. Install Backup Exec 2012 on the new server and apply all of the latest hotfixes and service packs. The…

930 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

9 Experts available now in Live!

Get 1:1 Help Now