Solved

Turning off DHCP on Cisco Pix 506E

Posted on 2006-06-25
2
2,086 Views
Last Modified: 2012-08-13
I will have to evEentually turn off the DHCP services running on my Cisco Pix 506E.  A Windows 2003 Server will be serving DHCP requests for local workstations.  What will I have to configure on the Cisco box via CLI?  

In other words can someone explain what will happen once I put a DHCP server on the network?  I would like the DHCP server to use the same scope that the Pix is currently using.
0
Comment
Question by:taki1gostek
2 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 16980150
You will have to disable the DHCP server service on the PIX before you enable any other DHCP server:
PIX506#config ter
PIX506(config)#no dhcpd enable inside
PIX506(config)#exit
PIX506#write mem

You don't have to do anything else on the PIX.
Just make sure that the scope on the Windows DHCP server cites the PIX inside IP as the router in the global settings.
0
 
LVL 2

Author Comment

by:taki1gostek
ID: 16980165
Got it.  That's what I thought!

Thanks!  Saved my butt again!
0

Featured Post

Highfive Gives IT Their Time Back

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

This solves the problem of diagnosing why an internet connection is no longer working. It also helps identify the likely cause of the lost connection if the procedure fails to re-establish your internet connection. It helps to pinpoint the likely co…
Cable Modem Provisioning from DPoE compliant server  This Article is to support CMTS administrators to provide an overview of DOCSIS compliance configuration file, and to provision a cable modem located at customer place from a Back office serve…
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

708 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

16 Experts available now in Live!

Get 1:1 Help Now