Solved

How to track down the source IP based on port number

Posted on 2006-06-28
2
753 Views
Last Modified: 2012-06-27
Hi,

Recently I noticed some abnomral utilization problem in one site. IP NBAR indicates eDonkey is taking a lot of bandwidth. Now the question is, how do I track down which IP is the source of these traffic? I don't think we can implement any packet analyzer, I am looking for any IOS command if it actually exists.

Thanks.
0
Comment
Question by:robinluo
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 12

Accepted Solution

by:
Scotty_cisco earned 125 total points
ID: 17003227
look at IP accounting ....
http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d169.html#wp1091971

enable various potions of it and use access-lists to pear down ports.

Thanks
Scott
0
 
LVL 9

Author Comment

by:robinluo
ID: 17006163
Thanks Scot.
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Cisco ASA 5512-X Active/Standby HA 4 49
Cisco WRVS4400N 11 71
adjusting startup config 6 76
Ping issue with M.M.M.M 13 41
While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question