Solved

Joining Catalyst 2960 to 3548 XL cluster commander

Posted on 2006-06-29
2
652 Views
Last Modified: 2013-11-15
I have a new catalyst 2960 switch that I am trying to add to a cluster.  The cluster command switch is an older 3548 xl switch.  I have tried several methods to add the switch, both command line, and through the Cluster Builder gui. Both ways result in a unreachable error.  I am wondering if there is a specific configuration needed on the 2960 to join the cluster?
0
Comment
Question by:Chuck_Butterbrodt
2 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 250 total points
ID: 17017687
I don't think the new 2960 even supports clustering. It was designed to use the Cisco Network Assistant. If you have not tried it as a replacement for your cluster manager, you might want to give it a whirl. CNA will manage your older 3548's too, and it's a free download.
http://www.cisco.com/en/US/products/ps5931/index.html
0
 

Expert Comment

by:rarockwell
ID: 21042124
0

Featured Post

Best Practices: Disaster Recovery Testing

Besides backup, any IT division should have a disaster recovery plan. You will find a few tips below relating to the development of such a plan and to what issues one should pay special attention in the course of backup planning.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
Workplace bullying has increased with the use of email and social media. Retain evidence of this with email archiving to protect your employees.
This tutorial will walk an individual through locating and launching the BEUtility application to properly change the service account username and\or password in situation where it may be necessary or where the password has been inadvertently change…
This tutorial will walk an individual through configuring a drive on a Windows Server 2008 to perform shadow copies in order to quickly recover deleted files and folders. Click on Start and then select Computer to view the available drives on the se…

823 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question