Solved

MUVPN help needed

Posted on 2006-06-29
3
285 Views
Last Modified: 2010-04-12
I have a MUVPN setup to connect to a Watchguard III 1000.  It connects without error, but I cannot do anything but ping server, workstations ect....  I cannot connect OUtlook to the exchange server or load a local Intranet website either by DNS name or IP address.

any suggestions would be greatly appreciated.
0
Comment
Question by:flg8tor96
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 77

Accepted Solution

by:
Rob Williams earned 500 total points
ID: 17022391
Any chance the remote and local subnets are the same? They need to be different.
0

Featured Post

Save the day with this special offer from ATEN!

Save 30% on the CV211 using promo code EXPERTS30 now through April 30th. The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Sometimes, you want your microsoft VPN to route all the traffic to the remote network. Usually your employer network. This makes it possible to access all the nodes inside this remote LAN, even if they have no "public DNS" entries. To do so, you wo…
When you connect to your workplace's VPN, you may not notice that you are using your workplace's servers to serve up webpages.  This might be undesirable since the workplace can log all the places you've been.  It also might be very slow to load pag…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

691 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question