Solved

How to Upload Image Cisco 3825

Posted on 2006-07-17
1
1,467 Views
Last Modified: 2008-01-09
I have a new image that I need to upload to my router. I have done it before in Rommon mode but I am not sure how to get into that mode. Please help.
0
Comment
Question by:gbauer17
1 Comment
 
LVL 12

Accepted Solution

by:
Scotty_cisco earned 250 total points
Comment Utility
I would not do it in romon but if you really want to when the device is booting up hit ctrl + break and it will drop you to romon

copy tftp flash works much better and faster though...

http://www.cisco.com/en/US/products/hw/cable/ps2217/products_configuration_guide_chapter09186a00801170d8.html

this is for a 7200 but same steps.

Thanks
Scott
0

Featured Post

Top 6 Sources for Identifying Threat Actor TTPs

Understanding your enemy is essential. These six sources will help you identify the most popular threat actor tactics, techniques, and procedures (TTPs).

Join & Write a Comment

Suggested Solutions

Title # Comments Views Activity
VPN Connection Failure 22 92
How to boost WiFi? 7 40
How to use a IP block on cisco 877 3 24
NSD FAIL 2 19
In a WLAN, anything you broadcast over the air can be intercepted.  By default a wireless network is wide open to all until security is configured. Even when security is configured information can still be intercepted! It is very important that you …
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

744 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

17 Experts available now in Live!

Get 1:1 Help Now