Solved

How to open remote desktop on Cisco 501

Posted on 2006-07-20
3
262 Views
Last Modified: 2010-04-17
I have Cisco Pix 501 that I need to enable remote desktop on.  I have a static Ip address assigned to the router and need to remote desktop to computers at this office.  I need to know what commands I need to type in order to have this work.
0
Comment
Question by:johnpatbullock
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 32

Accepted Solution

by:
rsivanandan earned 500 total points
ID: 17151436
The static ip you are mentioned is it a free one or it is assigned to the outside interface of the PIX ?

If it is assigned on the outside interface of the pix, then you'll have to do this;

static (inside,outside) tcp interface 3389 <InternalIPWhereYouWantRDPto> 3389

access-list <Name> permit tcp any interface outside eq 3389

Cheers,
Rajesh
0

Featured Post

Free Tool: Site Down Detector

Helpful to verify reports of your own downtime, or to double check a downed website you are trying to access.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

696 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question