Solved

How do i know if i'm using ipv6?

Posted on 2006-10-20
1
608 Views
Last Modified: 2006-11-18
I've been trying to disable this by adding  a line to resolv.conf but it hasnt seemed to work.
This is because my DNS recover is taking long periods of time. How do i know if ipv6 is
currently enabled?
0
Comment
Question by:steveZ1337
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 14

Accepted Solution

by:
pablouruguay earned 125 total points
ID: 17773624
in fedora distro for example

/etc/sysconfig/network-scripts/ and check the cfg gfile for your NIC and put IPV6=NO

with ifconfig you can find the v6 addr.

eth1      Link encap:Ethernet  HWaddr 00:13:02:7C:A9:B8  
          inet addr:192.168.1.146  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: 2000:1223:1754:0:213:2ff:fe4c:a9b8/64 Scope:Global    <----------- here you have the v6 address
          inet6 addr: fe80::213:2ff:fe7c:a9b8/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:168785 errors:0 dropped:142 overruns:0 frame:0
          TX packets:56493 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:58156185 (55.4 MiB)  TX bytes:5833148 (5.5 MiB)
          Interrupt:177 Base address:0x2000 Memory:dc100000-dc100fff
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
If you're a developer or IT admin, you’re probably tasked with managing multiple websites, servers, applications, and levels of security on a daily basis. While this can be extremely time consuming, it can also be frustrating when systems aren't wor…
Monitoring a network: how to monitor network services and why? Michael Kulchisky, MCSE, MCSA, MCP, VTSP, VSP, CCSP outlines the philosophy behind service monitoring and why a handshake validation is critical in network monitoring. Software utilized …

695 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question