Solved

Cisco 1710 - Change password

Posted on 2006-10-23
2
293 Views
Last Modified: 2008-03-06
What are the commands to change the passwords on a Cisco 1710 router when connecting via telnet? I have to give someone remote access and want to change the passwords when they are finished?
0
Comment
Question by:comtekso
2 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 17791909
router#config t
router(config)#line vty 0 4
router(config)#password newpassword
router(config)#end
router#

When done, just enter the same commands with a different password

To change the enable password:

router#config t
router(config)#enable password newpassword
router(config)#end
router#
0
 

Author Comment

by:comtekso
ID: 17795616
Excellent. Thank You.
0

Featured Post

Free Tool: Subnet Calculator

The subnet calculator helps you design networks by taking an IP address and network mask and returning information such as network, broadcast address, and host range.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Not able to route between subnets 8 123
Expanding Subnet Mask 20 153
SIP / Streaming - real time communications testing 8 99
BGP prefix and routing 3 61
While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

828 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question