Sorenson
asked on
Cisco FXS port Dial-peer - need to enter digits for paging zone when line goes off hook
Hello,
I need to configure an FXS port on a cisco router to link to our paging system.
I have configured the dial-peer, and it works, however the user needs to enter the "zone code" (ie: 03#) to identify the paging zone for output. Is there a way to configure the dial-peer to push this (03#) when the line goes off hook? I have played around with using prefix however it seems to shoot the digits through before the line goes on hook, even when I pad it with pauses. Any ideas?
current dial-peer configuration:
!
dial-peer voice 7500 pots
destination-pattern 7501
port 0/1/0
forward-digits 0
prefix ,,,,,0,3,
!
I need to configure an FXS port on a cisco router to link to our paging system.
I have configured the dial-peer, and it works, however the user needs to enter the "zone code" (ie: 03#) to identify the paging zone for output. Is there a way to configure the dial-peer to push this (03#) when the line goes off hook? I have played around with using prefix however it seems to shoot the digits through before the line goes on hook, even when I pad it with pauses. Any ideas?
current dial-peer configuration:
!
dial-peer voice 7500 pots
destination-pattern 7501
port 0/1/0
forward-digits 0
prefix ,,,,,0,3,
!
ASKER
The solution was to tune the interdigit dialing time and the tone generation time on the voice port itself. I will request this question be closed. thank you.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
see if this helps:
forums.whirlpool.net.au/fo