Solved

Can you use a regular Linksys wireless G router with a T-1 line

Posted on 2006-10-27
8
336 Views
Last Modified: 2010-04-17
I have a T-1 connection and was wondering if I can use a regular Linksys Wireless G router (the same as I use for my cable high speed connection) or if I need a higher level router.  If so, any recommendations?  
0
Comment
Question by:markcondiff
  • 3
  • 2
  • 2
8 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 85 total points
ID: 17820277
0
 

Author Comment

by:markcondiff
ID: 17820461
Is there anything else required with these routers for a wireless network or is this it?  
0
 
LVL 43

Assisted Solution

by:JFrederick29
JFrederick29 earned 40 total points
ID: 17820813
You could "convert" your Linksys Wireless router into an access-point by disabling the DHCP server and by not using the "Internet" port, simply plug one of the LAN ports into the LAN segment off the 1841 router.
0
PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

 
LVL 79

Expert Comment

by:lrmoore
ID: 17821987
I would have thought this would at least merit a split . . .
I did answer your original question
0
 
LVL 43

Expert Comment

by:JFrederick29
ID: 17822698
Yeah, I agree, lrmoore answered the original question.  If anything, at the most, I deserve a minor assist with minimal points.
0
 

Author Comment

by:markcondiff
ID: 17823558
Sorry, i didn't realize I got answers from 2 people.
0
 
LVL 79

Expert Comment

by:lrmoore
ID: 17823927
Thank you!
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

809 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question