Solved

Configuring 2 Cisco catalyst 4006 as a default gateway

Posted on 2006-10-31
5
440 Views
Last Modified: 2007-12-19
Hi

I have 2 x Cisco Catalysts 4006 that support 20 Cisco 2950s between 2 floors. Providing failover if one was to faiil. I would like to know whether i can configure them such that they act as my default gateway using HSRP i imagine. Is this possible? They would also have to share the same IP Address.

Also can the Cisco 2950s support separate VLANS on different subnets?

Regards

biggie
0
Comment
Question by:biggiesmallzz
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
5 Comments
 
LVL 50

Accepted Solution

by:
Don Johnston earned 100 total points
ID: 17847118
>I would like to know whether i can configure them such that they act as my default gateway using HSRP

Yes.

>Is this possible? They would also have to share the same IP Address.

No. The only address they would "share" would be the virtual IP address.

>Also can the Cisco 2950s support separate VLANS on different subnets?

Yes. Since VLAN's by defination are seperate subnets.

0
 

Author Comment

by:biggiesmallzz
ID: 17862912
Can you give me an idea as to how i would go about configuring the Catalyst 4006s to act as my default gateway? As i am unable to find a document.
0
 
LVL 50

Expert Comment

by:Don Johnston
ID: 17863369
Assuming that the 4006's are configured to route, you don't have to do anything. Just configure the PC's default gateway with the IP address of the 4006 route processor.

0

Featured Post

Free Tool: Path Explorer

An intuitive utility to help find the CSS path to UI elements on a webpage. These paths are used frequently in a variety of front-end development and QA automation tasks.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
Getting hacked is no longer a matter or "if you get hacked" — the 2016 cyber threat landscape is now titled "when you get hacked." When it happens — will you be proactive, or reactive?
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

717 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question