Solved

3com Switch Port

Posted on 2006-11-02
1
214 Views
Last Modified: 2010-05-18
Hi Exps,

One of the ports on our 3com switch just died today. Apart from physically plugging my Laptop into the switch to check for life can anyone advise how to identify the fault / reset the port?

Cheers
0
Comment
Question by:jonhagger
1 Comment
 
LVL 9

Accepted Solution

by:
jfrady earned 250 total points
ID: 17863926
Depending on the switch model you can look in either the web interface or command line to see the status of the port.  Plugging a known good device in to the port is somewhat of a good test.  Was a device in the port when it "died"?  
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
I had an issue with InstallShield not being able to use Computer Browser service on Windows Server 2012. Here is the solution I found.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

773 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question